To clean the sticky surface on the paddle base after using sports lubricant or water spray, gently wipe it with a soft cloth and let it dry. Then cover it with a protective film for a while.
No significant rubbing occurred in this case, as the ping-pong racket wouldn't stick to the pad due to the roughness of the ball. Clean the sponge with mild soap or dish detergent, avoiding harsh chemicals that may cause damage to the rubber coating. Wipe it several times with gentle running water, then thoroughly wash away.
Sixth time is enough for cleaning, maximum two times. Excessive usage can harm the rubber coating over time, causing the base to stick poorly. After drying, apply the protection film and reattach the paddle base. If the paddle base is made of synthetic adhesives, such as 729 or Hefei's organic adhesive, I prefer using them.
Note: The provided text appears to be correct except for one minor typo. It was incorrectly written "ball's" instead of "bat's" (base should be "bat"). Additionally, there is no punctuation in the title or headings, which might make it harder for readers to follow the content flow. Here's an updated version of the text:
Paddle Base Don't Stick to Sponge on Bottom of Badminton Court? To keep your paddle base from adhering to the spongy surface located near the bottom of a badminton court, you can follow these steps:
- Remove excess dust and debris: Before applying any cleaning solution, locate and remove any particles of dust, dirt, or other foreign materials on the paddle base. Use a soft cloth or a damp microfiber towel to gently clean the surface.
- Apply Sports Lubricant: Sprinkle a *** all amount of sports lubricant or water onto the paddle base, ensuring it covers all areas where the sponge might touch the plastic. This will provide a thin layer of lubrication that prevents the rubber from sticking together.
- Use Soft Dry Cloth: Using a soft, non-abrasive cloth, such as a microfiber towel or a damp microfiber pad, wipe the area between the paddle base and the sponge to remove remaining loose dirt or contaminants.
- Allow Dry Time: Let the damp cloth absorb the lubricant and air-dry completely before proceeding with the next step. Be sure to allow at least 5-10 minutes for the pad to dry before reapplying the protective film.
- Reapply Protective Film: To adhere the protective film firmly to the base, carefully peel back the existing film and align the edges. For easier application, cut the protective film slightly larger than the base's width.
- Install Protective Film Overlapping the Paddle Base: Place the protective film directly over the base, following the manufacturer's instructions for overlapping the base. Ensure the tape adheres securely and covers the entire spongy area without leaving any gaps or overlaps.
- Reassemble Spongy Surface: Once the protective film is installed, *** ooth out any wrinkles or uneven surfaces by gently pressing it into place. With the protective film in place, the rubber components on the paddle base should remain relatively static and secure.
- Avoid Abrasive Materials: When cleaning the paddle base with aggressive cleaning solutions like sports lubricants or harsh chemical cleaners, avoid touching the sensitive rubber coating directly. Instead, apply the product along the edges or in patches of exposed橡胶 to minimize potential damage.
By following these steps, your paddle base should maintain its grip and integrity against the spongy surface of the badminton court, reducing friction and preventing sticking issues. If the problem persists, consider checking if the table top or the paddle has been damaged or subjected to excessive pressure, or if the table is prone to spillage. In any case, always consult the manufacturer's guidelines for proper maintenance and upkeep.